Sublime Innocence: Online Writing Tips for freelance writers

Sublime Innocence: Online Writing Tips for freelance writers

Comments

Post a Comment

Popular posts from this blog

HOW TO SERVICE YOUR SMALL GENERATOR CARBURETOR

HOW TO SERVICE YOUR CARBURETOR!!!   Local generator repairers get about 60% of their income frrom just changing or servicing the carburetor. This DIY will not only save you money but also workshop labour. Now i'm guessing you've tried to srart your generator at this point and it's not responding or it shoots and goes back off, now go to the steps below......... STEP 1: DISMANTLING THE CARBURETOR firstly loosen the tank so you'll get enough space. then loosen the cover covering the carburetor(for small gens). Then you get the carburetor's bolts, loosen them also, move the board forwad so you can get to your carburetor. Unlock the throttle cable from the carburetor linkage. 2: Place it in a container to catch the fuel coming out, open the carburetor from bottom(you'll see a short bolt) loosen the bolt & remove the bowl. check for corrosion if there's corrosion you'll probably be needing a sandpaper to scratch of the corrosion and make the bowl...
Read more

"Sam's workshop": "Sam's workshop": MAINTENANCE TIPS

Is your generator nt responding? Here's a quick easy tip to check if your ignition system is still functioning.. PRIME THE ENGINE: how is this done? by opening the carburetor cover and pouring in a little fuel in it. Then try starting again, if it starts then goes off again then you have a carburetor problem..check out my previous post on how to service your carburetor.. If the Generator did not start atall then the ignition coils are faulty..loosen the plug, connect it to the starter coil(the one that goes to the plug). Pull the starter rope,it'll be free be careful not to touch the plug's tip to avoid electrocusion..move the tip of the plug close to any part of the gen's body(alumminum parts) and start gently..check for sparks if there's none, change the plug and try again..when yu get a spark tighten back the plug and start your generator.. But if there's still no spark the ignition system is faulty.. Contact sam's workshop at +2349034503380 OR se...
Read more

"HOW TO REMOVE CARBON PILE UPS FROM EXHAUST PORT AND MUFFLER"

Exhaust port is a passage through which the burnt mixture is passed out from the combustion chamber. it is located differently in different engine cyles. In a two stroke generator it is underneath the engine block while in a four stroke generator it is located on the left hand part of the cylinder. The exhaust muffler is connected to the port to reduce the sound from the generator and also to expel the harmful gas coming out from the engine. Mostly in two stroke engines; carbon usually piles up both at the exhaust port and inside the muffler thereby causing low RPM. In power generators this brings about low current. Removing carbon deposits is easy with this easy to follow steps: 1) loosen the exhaust from the exhaust port 2) get a long screw driver and drive it into the exhaust port, clean all carbon deposits from the port 3) use the screw driver to also clean the muffler through the hole..i usually pour in a little fuel in my muffler and light it up so it could dry up the carbon...
Read more